flyingemt
08-12-2015, 04:42 PM
All,
noticed after a carve yesterday, the hex head of a bolt laying in my carve. Upon examination, it was the lower left hand bearing bolt in the Z-Truck, (looking at it from the front).
The bolt shaft seems to still be able to hold the bearing in place and is functional.
Has anyone had this happen? This is my new CX machine, 6 mos old. Got the runaround from CW about the warranty, 1 year, so easier to go to Lowe's and get a replacement for 50 cents.
Mike
noticed after a carve yesterday, the hex head of a bolt laying in my carve. Upon examination, it was the lower left hand bearing bolt in the Z-Truck, (looking at it from the front).
The bolt shaft seems to still be able to hold the bearing in place and is functional.
Has anyone had this happen? This is my new CX machine, 6 mos old. Got the runaround from CW about the warranty, 1 year, so easier to go to Lowe's and get a replacement for 50 cents.
Mike