View Full Version : Err eo6 -0303
I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
Anyone??
henry1
07-29-2015, 08:43 PM
check your bearing probably binding
It goes to 59% then stops
fwharris
07-29-2015, 09:07 PM
It goes to 59% then stops
Does it always stop at this place in the carving?
Try reformatting the card.
bergerud
07-29-2015, 10:06 PM
Does anything special happen at 59%? Like, does the carve go deeper or wider?
No the error just comes up
yes it stops at same place
fwharris
07-29-2015, 10:29 PM
I would try reformatting the card and refresher the firmware. It you were running the same project back to back the card might of been corrupted.
bergerud
07-29-2015, 10:45 PM
Have you tried reformating and reflashing the card? Do you have a DC system? Have you moved the z truck up and down to see if there is a rough spot?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.