PDA

View Full Version : Err eo6 -0303



plaz
07-29-2015, 08:38 PM
I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
Anyone??

henry1
07-29-2015, 08:43 PM
check your bearing probably binding

plaz
07-29-2015, 09:04 PM
It goes to 59% then stops

fwharris
07-29-2015, 09:07 PM
It goes to 59% then stops


Does it always stop at this place in the carving?

Try reformatting the card.

bergerud
07-29-2015, 10:06 PM
Does anything special happen at 59%? Like, does the carve go deeper or wider?

plaz
07-29-2015, 10:14 PM
No the error just comes up

plaz
07-29-2015, 10:16 PM
yes it stops at same place

fwharris
07-29-2015, 10:29 PM
I would try reformatting the card and refresher the firmware. It you were running the same project back to back the card might of been corrupted.

bergerud
07-29-2015, 10:45 PM
Have you tried reformating and reflashing the card? Do you have a DC system? Have you moved the z truck up and down to see if there is a rough spot?