View Full Version : Combat SeaBee Plaque- Not Carving- Little Help
Jerrylouismartin
07-17-2015, 08:20 AM
7702277023
I have made this plaque a couple of times and for the life of me I cannot figure why it won't Carve the CAN DO on the bottom and the rope does not fully carve aLSO.
Plaque too busy?
Any Help would be appreciated!
I have posted the picture and the .mpc.
Thanks!
JLM
bergerud
07-17-2015, 08:34 AM
It looks to me like your head is not level. Check the the lead screw on the right side. The nut may be stripped.
Part 61: http://store.carvewright.com/home.php?cat=384
zan29
07-17-2015, 09:44 AM
It happened to me once and it the head not being leveled was the problem.
SteveNelson46
07-17-2015, 12:26 PM
I also agree with Suzanne and Dan. I think your head needs to be re-leveled.
SteveNelson46
07-17-2015, 01:09 PM
You can find the head leveling procedure and documents here:
http://www.carvewright.com/assets/service/Service_instructions/CarveWright_service_level_head.pdf
SteveNelson46
07-18-2015, 01:01 AM
I just did a search in the pattern depot and someone else has made an oval rope border that is almost identical to mine and is selling it for $5.00. I have removed my version from all posts.
papawbummie
07-18-2015, 03:38 PM
I am looking for a rotary pattern of a beer bottle with top on or off Thanks Bert
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.