Not an error message ?

[myshop1044]

Where do you go on the key pad to turn off the question "cut the board" during setup.
Each time you run thru the set up questions, I don't want to answer that question.
Perry B.

[RMarkey]

from the main menu, 0-5-4

[DianMayfield]

Now, THAT was worth the price of admission!!

Thanks so much :)

[myshop1044]

hey , if you don't ask, you never learn!!!

[myshop1044]

just clear up a question earlier, I should have "cut the board to size" not cut thru board.
I went to 0 5 4 and turn back "ON" , cut thru board", then I arrowed down and found the "prompts" and selected
"cut the board to size" and turned it off.
Perry B.

[skeeterman]

Going to do this now, that is annoying each time it pops up
Steve

[myshop1044]

I just found out that "B" and a "C" machine has 2 different prompts after you enter 0 5, "B" and the "C" are equal until you reach "4", the "C" has "prompts",
from there you can go to 1- cut thru prompt , 2-roller(ask), 3-cut to size, then it goes on 5, 6, 7, 8-lock machine.
The "B" machine matches up 4, then it states "cut thru prompt" and no other options from there, then it moves on to 5, 6, 7. (no 8)
I can not turn off "cut board to size" on the "B" machine.
any help would be great. someone else give this a try if you have a "B" and a"B" machine.
Perry.

[bergerud]

You must be mistaken. The firmware is the same on all the machines. It is the same program.

0-5 is User Options Menu
0-5-4 is Prompts
0-5-4-1 is cut thru?
0-5-4-2 is Rollers?
0-5-4-3 is Cut to size?

Is not 0-5-4-3 the cut board to size?

[myshop1044]

0 5 4 has "cut thru prompt" , arrow down to 5 -meas. system ,etc.

[bergerud]

My machines are B. Press 0-5-4-3 and see what you get. Maybe something is wrong with the arrow button.

[myshop1044]

0543 states scanner type

[bergerud]

Scanner is 0-5-3. I have it! Your 4 button does not work.

Type 0-5. Arrow down to 4) Prompts enter then arrow down to 3)

[myshop1044]

I have one better, t's the version on the flash card, 187, when I put the newest version fron another card it worked just fine. I placed the old flash card with 187, it failed on the " C" machine. I thought I was going nuts, maybe it's the 97 degree weather over here.
thanks for the input.
Perry B.

[bergerud]

So, not the same program! Good you got it figured out.