View Full Version : Jogging to position using 60-degree V bit
mwunderlin
07-09-2015, 11:06 AM
I am trying carve some words into a board using the 60-degree V bit but I also want to Jog To Position on the keypad but when I select Jog To Position the only bit choices I have is to use the carving bits not the 60-degree V bit, can you not carve using the 60-degree V bit and Jog To Position or am I doing something wrong?
Thanks for your help
Version 3.102
bergerud
07-09-2015, 11:17 AM
The jog to position operation uses the carving bit as a pointer. It will ask you later to put in the V bit. Just go for it, it will work out.
mwunderlin
07-09-2015, 11:23 AM
Thanks for the information, I did not go past the part asking for the carving bit so I will give it a try.
Thanks for your help
zan29
07-09-2015, 01:10 PM
You learn something everyday, I didn't not know that either!
rcdages
07-09-2015, 02:03 PM
Every day we seem to learn something.
That helps us grow.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.