View Full Version : bagpipe
henry1
06-30-2015, 09:37 AM
I am looking to get this pattern again can't find it any were any help appreciated they don't have it the carvewright store anymore
bergerud
06-30-2015, 09:40 AM
Do you have it in an mpc? If so, you can extract it into your favorites. (You cannot export it as a .ptn though.)
henry1
06-30-2015, 10:28 AM
Do you have it in an mpc? If so, you can extract it into your favorites. (You cannot export it as a .ptn though.)
I know about that but I did purchase it and it is license , it for another member is there another way around it
zan29
06-30-2015, 10:29 AM
I have this one for you Henry!
76725
bergerud
06-30-2015, 10:38 AM
I know about that but I did purchase it and it is license , it for another member is there another way around it
Do you mean another user wants to buy it?
henry1
06-30-2015, 10:47 AM
Do you mean another user wants to buy it?
yes,, but its not there anymore that why I am looking for another one the same if possible
fwharris
06-30-2015, 11:05 AM
You might try calling CarveWright as the "Firmware Lord" did say it is in the store but it shows in a "hidden" state. Not sure if this is because the vendor is not longer active or if they have the item set up wrong. Since the conference is all done they should now have time to look at it and get you a good answer.
henry1
06-30-2015, 11:55 AM
You might try calling CarveWright as the "Firmware Lord" did say it is in the store but it shows in a "hidden" state. Not sure if this is because the vendor is not longer active or if they have the item set up wrong. Since the conference is all done they should now have time to look at it and get you a good answer.
Ya right been trying for a few days now,, don't know what to say
RMarkey
07-01-2015, 01:21 PM
What I understand is Vector Art 3D (the makers of the pattern) lost their artist who made the pattern, so they cannot sell it anymore.
lynnfrwd
07-01-2015, 10:59 PM
Ya right been trying for a few days now,, don't know what to say
Henry, I don't understand why you consistently can't get through to us. Sometimes we go half hour or more without phone calls. Don't call at 9:00 am or at 1:30 pm. Let it ring until we can pick up. It rotates between the different support staff. Rarely, do we miss a call. Are u getting the recording? What number are you selecting? What number are you dialing?
henry1
07-02-2015, 05:36 AM
What I understand is Vector Art 3D (the makers of the pattern) lost their artist who made the pattern, so they cannot sell it anymore.
That is understandable and connie all is good now thx
Alan Malmstrom
07-02-2015, 10:46 AM
I made some bagpipes a long time ago and have just uploaded the pattern to the pattern depot. I don't know when it will be available but you can check under vendor Work of Art Designs.76766
Alan Malmstrom
07-02-2015, 04:20 PM
The bagpipes have been listed: http://store.carvewright.com/product.php?productid=25252&cat=&page=1
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.