Pow mia

[dehrlich]

Does anyone have a super clean POW MIA carve pattern? Trying to get ready for the annual vet reunion. I want to carve it into some expensive wood and the one I have is ok, but it gets "pecky" around the edges. I'm going to put some walnut burl veneer on curly maple, so I need clean edges etc. Posting the one I have. Thanks in advance.

76709

[fwharris]

There is a good one in the pattern sharing section. http://forum.carvewright.com/showthread.php?21181-Pattern-Sharing-Depot-Attachment-List&p=182823#post182823

[henry1]

will this do , just work it abit

[dehrlich]

Thanks Henry, but I need the old version brother... can you convert please?

[henry1]

Thanks Henry, but I need the old version brother... can you convert please?

here you go

[oscarl48]

I know a lot of us on here are vets. As an alternate let me give it a try at creating a new pattern as well. I'll actually put some time and effort so it may be a few hours after work tomorrow. This one we should all have in our library.

[oscarl48]

I know I am going to pay for staying up so late tomorrow at work but I am fairly pleased with the results. There is a little jaggedness on the bottom right wires but overall a clean stl port.

The image is a pattern so you will have to play on how you want to carve it. The picture shown is 15"x15" board. POW pattern at .1 depth at 100 height. Bit optimization optional. Rectangle surrounding the pattern set at .2.

Enclosed is also an image render of the model I made.

[dehrlich]

here you go

is that 1.187? Still won't open for me. Sorry to be a pain... one day I will upgrade. Just got conforming vectors a few months ago... being on a limited income sucks.