View Full Version : Toolbar help?
Loriblackdog
06-26-2015, 09:15 AM
Hi,
The other day I was able to use the toolbar, now I have the toolbar showing, however it is all greyed out and I cannot use it? I did move a couple of things around. Did I do something wrong or miss something? If anyone is good with toolbar, I would appreciate the help.
Thank you
Loriblackdog
This is what happens, I click designer, import frm file, choose my file, then save. at this point it takes me bck to designer blanck screen, I thought once I saved to file I could then hit the red X, delete that and rename my work? I am not sure what I am missing??? Thanks for your patience.
Lori:-P7667876679
bergerud
06-26-2015, 09:36 AM
Which toolbar? Could you post a screen shot?
zan29
06-26-2015, 09:44 AM
Lori, your toolbar is greyed out when you don't have a board in place. Try starting a new project and it should work.
Loriblackdog
06-26-2015, 09:48 AM
Hi Zan29,
Thank you, I know it is right there in front of me, I will get all the steps eventually.
Thank you
Lori
bergerud
06-26-2015, 10:49 AM
Nice call Suzanne.
bergerud
06-26-2015, 11:16 AM
Sometimes when more than one project is open and one project gets closed, some of the toolbars are grayed out. One has to open another project to get them back.
I have the same problem. 84226 I can't choose a bit.
lynnfrwd
05-26-2017, 10:51 AM
Tools are grey when you DON'T have something selected that they can be applied to.
Select Bit will not show unless you have something selected that you can apply a bit to...like a path.
thank you for the reply Lyn but still greyed out . As you can see in this pic I have the pattern selected. 84227
fwharris
05-26-2017, 12:29 PM
thank you for the reply Lyn but still greyed out . As you can see in this pic I have the pattern selected. 84227
That is a pattern and the default bit is the 1/16" ball nose bit. The bit select tool does not work for this, if you want to select a different carving bit for the project go to "board settings" and select the different bit for your project. This will change it for all of the pattern/raster carves on the board.
lynnfrwd
05-26-2017, 01:46 PM
That is a pattern and the default bit is the 1/16" ball nose bit. The bit select tool does not work for this, if you want to select a different carving bit for the project go to "board settings" and select the different bit for your project. This will change it for all of the pattern/raster carves on the board.
Correct. Change the carving bit by going to Edit > Board Settings > Pattern Bit. It WILL apply to all raster carving on project.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.