View Full Version : Problem with Make Vector Group
mikemi
06-12-2015, 12:08 PM
I have used Make Vector Group in the past and it worked just fine. Now for some reason I can't even get it work correctly with just a simple square and circle that are not overlapping. After I create the circle and square in designer and then click on the icon for Make Vector Group, the next window opens and I select all and then OK. At this point, it just goes back to Designer and all I see are the vector lines I created with nothing else shown. I have tried different settings within the hardware acceleration, but nothing seems to work. Suggestions PLEASE. :confused:
Thanks in advance,
Mike
bergerud
06-12-2015, 12:37 PM
Click on the shapes in the vector group window before you press ok?
mikemi
06-12-2015, 01:25 PM
Click on the shapes in the vector group window before you press ok?
Dan,
I am not understanding what you mean. I don't see anywhere to click on shapes. I have attached some pictures of what I see when trying to Make Vector Group.
Mike
bergerud
06-12-2015, 02:04 PM
Click on the green.
mikemi
06-12-2015, 02:15 PM
Thanks Dan, I knew it would be something simple. I had even read both the PDF tutorials on doing the chip carving and it just didn't sink in.
Mike
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.