View Full Version : Just a simple carved arc - why isn't it exact
kelsky
06-03-2015, 08:08 AM
a line with a sweep with an arc in it. I am needing this to be exact, but the software is not allowing me. Basically I have a line that I need carved as an arc. .295 deep with an arc of .295 in its radius. As you can see from the picture, this will not make a perfect arc. See the straight edge towards the top of the edge? Any advice?
76391
bergerud
06-03-2015, 08:30 AM
What version of Designer are you using? Can you post the mpc? Have you tried extrude? (It is a sweep bug that has not been fixed. A problem with vertical sides if I recall.)
kelsky
06-03-2015, 09:13 AM
Designer 3.102
76393
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.