PDA

View Full Version : Project Unreadable Error


shoe2728
03-09-2007, 08:15 AM
Have tried about everything, cleaned machine reflashed card, formated card, tried different patterns. But every time machine starts and cuts about 5%, then stops with Project Unreadable Error (6) Press Stop to Abort. Have not installed 1.20 still using 1.19 Any ideas appreciated.
Cliff
03-09-2007, 09:03 AM
More input please.

Size of the project. Type and length/width of wood used. Copy/picture of pattern if possible for analysis.

Cliff
shoe2728
03-09-2007, 03:41 PM
I had already cut two of these and they cut fine, board was 26L 7.25 W x3/4 pattern was 22x6. I also tried the Lion (by its self) that is already a freebie in the favorites, on the same board in the middle. Same result cut about 5% and same error.
Cliff
03-09-2007, 04:15 PM
Found this in the Troubleshooting forum.

http://www.carvewright.com/forum/showthread.php?t=2672

Your best shot is to contact CW and have them walk you through checking the cable connections.
Ron Baird
03-09-2007, 04:36 PM
First you should upload 1.120 It is a fix for 1.119 that has several bugs in it. Your problem could be caused by one of the bugs.
Second, that error you will also get if the flash card has gone bad and if that is the case the only fix is a new card. I had one go bad after several months of use and it was all of a sudden and could not be fixxed by reloading or anything else.