pattern help

[aokweld101]

I'm trying to do this with the image program I am wanting to have the canopy .125 pocket cut intruded and the cut out.. I've tried what I know and it 's not working could some one tell me or help me do it..it's air carving the cut out and a .25 on the pocket cut.

[bergerud]

Do you want to do something like this? (I quit half way)

[aokweld101]

Yes Dan, I have been trying since yesterday morning, I've tried making a pattern of the canopy, copy and paste and everything in my arsenal of knowledge....but...but...but I just want what you done .125 deep. and the cut out. Thanks Dan, The pattern is of wind type, boats with sails, three of them that turn on a pivot point in the center and turn in the wind.. after get this done I'll post how it works..as you said in a post I'm amazed as soon as the bit hits the board.

[bergerud]

Something like this is not that hard to do. I made a 0.1 snap grid and just filled in the pocket.

[aokweld101]

I've been missing with it a little since the last post it was easier do, and work the dimension, than try to over think it...