View Full Version : vertical lettering
makinsawdust
05-04-2015, 06:09 PM
I need to carve no's and letters on a 4" x 4" post. house number and street name, except I do not see how to do this with software.
Will I have to do it somewhere else & import, ie; I use CorelDraw x7.
Any suggestion's from you great experts
makinsawdust
DocWheeler
05-04-2015, 07:02 PM
One character at a time and rotate and size each of them.
Dan's suggestion is better!
The only problem that I've had with that is lining-up different width letters and numbers.
bergerud
05-04-2015, 07:31 PM
Just type the numbers, each followed by a carriage return. The rotate the whole thing 90
Digitalwoodshop
05-05-2015, 11:54 AM
Or make each letter a seperate item. Then position as needed.
makinsawdust
05-05-2015, 01:35 PM
Thank you
Stan
James RS
05-05-2015, 05:16 PM
75990
75991
I just put in text applying the center on board and hit enter after each character, then select all and rotate
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.