3/16 carving bit

[johnfour]

I am relatively new to Carvewright. How do you tell the machine that you want to use a carving bit larger than 1/16" when doing a raster carving?

[mtylerfl]

I am relatively new to Carvewright. How do you tell the machine that you want to use a carving bit larger than 1/16" when doing a raster carving?

Go to Edit/Board Settings/Pattern Bit/Select Pattern Bit

(By the way...the Test forum is NOT the place to post any questions. Please post in the appropriate category to be sure you will receive a response in the future.)