View Full Version : 3/16 carving bit
johnfour
04-20-2015, 03:27 PM
I am relatively new to Carvewright. How do you tell the machine that you want to use a carving bit larger than 1/16" when doing a raster carving?
mtylerfl
04-21-2015, 09:35 AM
I am relatively new to Carvewright. How do you tell the machine that you want to use a carving bit larger than 1/16" when doing a raster carving?
Go to Edit/Board Settings/Pattern Bit/Select Pattern Bit
(By the way...the Test forum is NOT the place to post any questions. Please post in the appropriate category to be sure you will receive a response in the future.)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.