PDunn
03-25-2015, 08:46 AM
I was trying my rout mode with version 3 , and find that I get a error msg e16-0961 on all phases of rout <end , All Edge , im using a 3/4 board and tried setting it to board depth both 3/4 and 1/2 inch incase it was using my 1/2 roundover bit , any ideas ?
fwharris
03-25-2015, 11:02 AM
I believe most do not use the edge route function on the CW.
lynnfrwd
03-25-2015, 11:19 AM
Edge rout tends to work better as a stand alone function than it does through the design software.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.