anyone else getting issues with the Rout mode

[PDunn]

I was trying my rout mode with version 3 , and find that I get a error msg e16-0961 on all phases of rout <end , All Edge , im using a 3/4 board and tried setting it to board depth both 3/4 and 1/2 inch incase it was using my 1/2 roundover bit , any ideas ?

[fwharris]

I believe most do not use the edge route function on the CW.

[lynnfrwd]

Edge rout tends to work better as a stand alone function than it does through the design software.