View Full Version : Experimental Board Carrier
bergerud
04-13-2016, 11:11 AM
Dan
All of my previous times using the carrier were on a machine with rubber belts, I would like to start using another machine that I have that has the sand paper belts.
Are there any problems with doing that?
Rubber or sandpaper, it does not matter.
Sliverfoot
04-13-2016, 12:30 PM
Thank you Dan.
Sconi
01-21-2017, 02:39 PM
Been using the original UCB for a while and now that I have a second machine I find myself in need of an additional one, I have been skimming through the posts on this topic and need a summary of what advantages/benefits between the original and the protected one with additional holes. I see there are no stop blocks so was wondering how to make sure you get in the right place to so a two sided carve and if the additional holes are only for clamping if needed.
Thanks
mjc
bergerud
01-21-2017, 02:45 PM
I put a 1/4" bolt in a top hole to act as a stop. I would post a picture but it is in the machine carving right now!
bergerud
01-21-2017, 02:58 PM
Look closely at the picture in http://forum.carvewright.com/showthread.php?27235-Experimental-Board-Carrier&p=249420#post249420
and see the bolt on the far side to the right. (The board now slides in and out the front.)
Sconi
01-23-2017, 11:31 AM
Thanks, that is what I needed to know!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.