jogging video

[henry1]

Is there a video on jogging not sure what to do when ask to jog on the project

[bergerud]

There are two jog operations. One is to jog to where you want the bit to touch the board. The other is to jog to where you want to place the center or corner of a project on the board.

[ktjwilliams]

Good question ,,, I've been meaning to experiment and see exactly what it does ...

[bergerud]

There is also another jogging operation, new to Designer 2 for double sided carves. The flip-in-jig feature. When you use this, you are asked to jog to one front corner on the back and the other front corner on the front (actually the same corner since it was flipped).

[ktjwilliams]

I have 2 and have never even seen that one .. Thx Dan Now I'll have to search around for that feature ,, LOL

[fwharris]

There is also another jogging operation, new to Designer 2 for double sided carves. The flip-in-jig feature. When you use this, you are asked to jog to one front corner on the back and the other front corner on the front (actually the same corner since it was flipped).

Link to the subject http://forum.carvewright.com/showthread.php?25462-Two-Sided-Carves-New-quot-Flip-Within-Jig-quot-feature-of-2-005&p=227429#post227429