View Full Version : rotary lithopanes
aokweld101
02-17-2015, 09:05 AM
when doing the a cpvc pipe do you need the long bit?
bergerud
02-17-2015, 09:16 AM
No. You can use the normal carving bit. As long as the bit will reach to the depth you want to carve, I think you are good to go.
aokweld101
02-17-2015, 09:25 AM
Thanks Dan, it also says to drill a 7/32 hole for the centers... what are the #screw size and length for the two set screws?
bergerud
02-17-2015, 09:28 AM
Thanks Dan, it also says to drill a 7/32 hole for the centers... what are the #screw size and length for the two set screws?
I do not know, I use my own jig which is a little different. Any screws which fit should be ok I think.
aokweld101
02-17-2015, 09:40 AM
All right, I still thank you for the reply... You being a teacher don't you recieve a discount for it being a learning aid ... you know to get the new and improved stuff...lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.