flyingemt
02-15-2015, 08:09 PM
All, I am wanting to use a 5/4" piece of walnut for the base of a memorial flagcase.
I have programmed the carve regions to be two (2) 3/4" x 4" cuts and a 3/32" width cut the span between them for the glass.
Now, how much offset/inset should I need to make the widths perfect as I seem to be 1/16" too wide using the 1/16" carve bit.
See attached mpc.
Flying...74503
I have programmed the carve regions to be two (2) 3/4" x 4" cuts and a 3/32" width cut the span between them for the glass.
Now, how much offset/inset should I need to make the widths perfect as I seem to be 1/16" too wide using the 1/16" carve bit.
See attached mpc.
Flying...74503