View Full Version : Jointing bit
PDunn
01-25-2015, 08:24 AM
I just ran across a new msg on my machine asking for a 3/8 jointing bit , any ideas , because I have not a clue thanks
henry1
01-25-2015, 08:28 AM
I just ran across a new msg on my machine asking for a 3/8 jointing bit , any ideas , because I have not a clue thanks
All the bits you got with machine are the jointing bit there is a 3/8 there if you did get them
bergerud
01-25-2015, 09:09 AM
I just ran across a new msg on my machine asking for a 3/8 jointing bit , any ideas , because I have not a clue thanks
Are you running the machine calibration routine or is the 3/8" jointing (straight) bit being used in a project?
PDunn
01-25-2015, 05:33 PM
For a carving on a box it was never listed on my bit list
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.