PDA

View Full Version : New 1/32" Carving Bit



Canemaker
01-24-2015, 08:41 PM
Has anyone purchased this new bit and done carving. I'm interested in knowing how the quality of the carving and what materials you have tried.
In addition has anyone tried using this bit to obtain smaller carving that couldn't be achieved with the previous bits.

Thanks
John

bergerud
01-24-2015, 08:48 PM
I think that if you put a finely detailed pattern on a board in Designer you will be able to see the difference when you change the pattern bit back and forth between the 1/32 and the 1/16. (Remember to use bit optimization best.) That is what I did. I have not given it a real try yet.

Canemaker
01-24-2015, 09:49 PM
Thanks for the information, I'll try that.