View Full Version : cfederate
cfederate
01-19-2015, 05:44 PM
I need help with the scanning probe. I am able to lay everything out on the sled but the scanning probe will not raise up to go over what is being scanned. What am I doing wrong?
bergerud
01-19-2015, 06:27 PM
See if the probe is working. Press 0 - 7 and arrow down to the probe test. It should change from closed to open when you deflect the probe.
cfederate
01-24-2015, 02:15 PM
When I do the test, it does not change. This is the second probe I have gotten.
bergerud
01-24-2015, 02:38 PM
The display should also change to scan when you plug the prob in. Check the wires from the scanner plug around to the plug in the circuit board beside the y motor.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.