View Full Version : First lithophane... not quite right
cjudas
12-27-2014, 12:58 PM
73612
This is my first try at a litho but I'm doing something wrong. The edges are way too thin and one cracked. Any help is greatly appreciated. I don't know how to attach the .mpc.
fwharris
12-27-2014, 01:03 PM
You attach the mpc the same way you did the image. Browse to the location and select it.
What depth/height settings and feather did you use? Was it on 1/4" or 1/2"?
cjudas
12-27-2014, 01:09 PM
It was on 1/4" corian, and used the settings in the tips and tricks. I believe .180 depth and 450 height. I will try to send mpc
cjudas
12-27-2014, 01:12 PM
73614 Here is the mpc
aokweld101
12-27-2014, 01:41 PM
I'm not that great at proof reading but your thickness is set at .75 instead of .25
aokweld101
12-27-2014, 01:48 PM
Here is what I mean.
cjudas
12-27-2014, 01:50 PM
Yes it is. I will change that, thank you
fwharris
12-27-2014, 04:06 PM
It was on 1/4" corian, and used the settings in the tips and tricks. I believe .180 depth and 450 height. I will try to send mpc
If that was the mpc you used your setting was .250 for depth and 100 for height. If so then that would explain why it carved through. Changing it to .180 and 450 should get you what you want.
cjudas
01-24-2015, 04:12 PM
Thank you, I finally got time to try the changes you suggested.74041
Canemaker
01-24-2015, 05:30 PM
Great looking litho, congrats on a successful feat!~
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.