jerrbitt
12-11-2014, 05:49 PM
Another strange event with the machine. After doing two lengthy carves involving thru-the board cut ( 1/8 inch cutting bit) I encountered a Z axis stall on the third project.
After reloading two or three times, I continued to get the same message, Carvewright told me it was either the cut motor or the FCC 9?)cable.
So rather than ordering the cable, I did a simple project involving a text pattern and a 3/8 inch keyhole slot. That worked with no stall.
I edited the pattern and eliminated the thru-the-board cut and everything went as it should.
But my inquisitive nature asks why?
Any ideas.
After reloading two or three times, I continued to get the same message, Carvewright told me it was either the cut motor or the FCC 9?)cable.
So rather than ordering the cable, I did a simple project involving a text pattern and a 3/8 inch keyhole slot. That worked with no stall.
I edited the pattern and eliminated the thru-the-board cut and everything went as it should.
But my inquisitive nature asks why?
Any ideas.