can some one peek at these

[PDunn]

can some one peek at these and tell me if they will line up right its a double board carve 28wx36 long 0.50 thick , and want to know if they look right 7332273323

[DickB]

Have you done a two-piece project before? Laid out as you have it, you are going to get a warning about interference with the compression rollers. I leave a 1" strip uncarved in my projects to avoid issues. I also fasten a temporary strip to the boards to avoid waste.

73324

[PDunn]

I haven't done a 2 piece yet , so make it 15 instead of 14 for the width ?or come in 1 inch and narrow the project my boards are 16 wide , still have to cut them down and did I line up things the way they should be

[unitedcases]

I haven't done a 2 piece yet , so make it 15 instead of 14 for the width ?or come in 1 inch and narrow the project my boards are 16 wide , still have to cut them down and did I line up things the way they should be
Mtyler did a tutorial on it. It's called tiling. Not difficult but definitely worth the time to read.

[DickB]

I don't think a 15" board will fit. Place a 1" mask over your pattern. Place the center of your project at least 1" from the edge of the board. That 1" of your board will get sacrificed when you join the boards together.

Don't use the mpc I attached - it's just for illustration. You'll need to lay your project out as you see fit.

73326

[PDunn]

Thanks Dick ill make the adjustments and update

[DickB]

BTW I think you should uncheck the Floor Feather option on your pattern as well.