View Full Version : WTB Carvewright
keithfrom
11-27-2014, 07:50 AM
I am looking to buy a well maintained machine.
Age and hours do not bother me if the machine
has been maintained and cared for.
This is my first time buying a CNC and after doing
my due diligence for the last 3 months, I believe the
Carvewright is the correct choice for my needs.
I live in Fort Worth, TX, so must be willing to ship
if farther away then 300 miles.
Thank you,
Keith
CW-HAL9000
11-27-2014, 08:00 PM
Sent you a private message.
cestout
11-29-2014, 01:58 PM
You will have to pay for any software from LHR.
Clint
CW-HAL9000
11-29-2014, 02:42 PM
You will have to pay for any software from LHR.
Clint
Except for basic designer 1.87
cestout
12-01-2014, 06:37 PM
You can only get 1.187 free in demo mode I believe. To upload to a card you need a license. Used machines come softwareless.
Clint
CW-HAL9000
12-01-2014, 07:01 PM
You can only get 1.187 free in demo mode I believe. To upload to a card you need a license. Used machines come softwareless.
Clint
No all you have to do is transfer machine registration into your name. All LHR requires is a receipt showing you purchased the machine. It can be any receipt that shows you purchased the machine from someone. You email the receipt to support with an email requesting transfer of machine to your name. Once the machine is transfered to your name you get basic designer 1.87 which you can register on up to two computers. I know this because both my machines were purchased by me used. I went through this process twice.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.