PDA

View Full Version : Infeed outfeed tables



shoe2728
03-01-2007, 12:56 PM
searched and cannot find anything on adjustment. should the tables be adjusted as similar to a planer. My in/out tables were high, just wonder if they should be adjusted.
thanks

HandTurnedMaple
03-01-2007, 12:58 PM
Just like a planer. There is a bolt/nut under the back of the roller.

Skyhawk
03-01-2007, 01:05 PM
Mine were high as well, which I think led to the tearing of the sandpaper belt on my system...(adding to much pressure).

For anyone unsure of the adjustment, they should be adjusted with a long straight board, touching each roller at the same time, with some pressure loaded onto it so that the rollers barely touch the wood...

-Jim

pkunk
03-01-2007, 01:25 PM
searched and cannot find anything on adjustment. should the tables be adjusted as similar to a planer. My in/out tables were high, just wonder if they should be adjusted.
thanks Adjust them absolutely level with the bed or if lifting occurs the board sensor will not detect the board properly.