Roy Fleshman
09-16-2014, 12:56 AM
I place this is the newbie section because I am still at that stage and will be for a bit.
Still learning all the ins and outs. Used the 90 degree v tool to centerline cut very small letters. Was impressed. I had made the Caltrans logo a few days ago using the software. The California bear was pulled off the net as a jpeg. Tweaked it in pattern editor for a few moments, just to see what each tool would do. And sent it to the CW. I am not completly happy, the California state and bear was not what I wanted. . Wanted them both proud with the bear a little higher than the state. An easy fix would be to make them seperately And place the bear on the state. I will try that next. Anyway this will make me a few brownie points at work.
As always any input or ideas are most welcome.
Cheers
71747
Still learning all the ins and outs. Used the 90 degree v tool to centerline cut very small letters. Was impressed. I had made the Caltrans logo a few days ago using the software. The California bear was pulled off the net as a jpeg. Tweaked it in pattern editor for a few moments, just to see what each tool would do. And sent it to the CW. I am not completly happy, the California state and bear was not what I wanted. . Wanted them both proud with the bear a little higher than the state. An easy fix would be to make them seperately And place the bear on the state. I will try that next. Anyway this will make me a few brownie points at work.
As always any input or ideas are most welcome.
Cheers
71747