Edge routing

[Bob Victor]

My question is, after applying an edge rout to a project and saving it, I wanted to change or remove the applied edge routing. I have yet to figure out how to do it. Any help???:confused:

[ktjwilliams]

Just select it and use the red X to delete it .. or highlite it in the carve list n hit the red X to delete ...

[lynnfrwd]

Just FYI...edge routing a rectangular or square board is best done with the standalone feature rather than as part of the project. Less chance of mistracking when it comes out from under rollers.

[Bob Victor]

Thank you....It worked.

[Bob Victor]

I prefer to finish project from standalone equipment. That was the reason for removing edge routing from project. The suggestion given my ktjwilliams, worked..

[dehrlich]

You can also select it, go to the "select bit" menu and just hit the "no bit" button. That removes it from the project too. Just FYI for the future.