truckman94
09-07-2014, 11:36 AM
Hello everyone,
I am trying to carve a name on the stile of a cabinet door, but I can not figure out how to rotate the writing:?:. I need it to go one letter at a time starting at the top till it reaches the bottom. I am using just the standard software that comes with the machine, Any help would be greatly appreciated.
I am trying to carve a name on the stile of a cabinet door, but I can not figure out how to rotate the writing:?:. I need it to go one letter at a time starting at the top till it reaches the bottom. I am using just the standard software that comes with the machine, Any help would be greatly appreciated.