PDA

View Full Version : cut path



fg9074
02-26-2007, 11:53 PM
I have seen the winds grill & am wondering how to achive the cut thru. Is this a cut path or is it simply setting the depth to the thickness of the board ? If it is setting the depth equal to the thickness does the machine leave tabs? I want to try something simualar but dont want to mess anything up.

forqnc
02-27-2007, 06:45 AM
Check out this thread.
http://www.carvewright.com/forum/showthread.php?t=1297&highlight=winds

fg9074
02-27-2007, 07:10 AM
Thanks for this lead, I thought I had seen every post on the forum, where are all these instuctional posts located ? Again thanks for taking the time to head me in the right directin.

Charles M
02-27-2007, 07:18 AM
That thread is from May 2006 and I note that the forum only goes back 4 weeks now.

HEY MODS, is there somewhere we can see the archived threads?

Jeff_Birt
02-27-2007, 07:27 AM
The forum software was recently updated but all the threads are still there. At the bottom of the page on each forum is some navigation arrows <1235>.

Charles M
02-27-2007, 07:43 AM
Jeff,

I see those. However, when I go to the last page I only see the threads going back four weeks. I know I'm not always the sharpest cutting bit in the machine but thought I had a pretty good grasp of how to navigate. Any help is appreciated.

Jeff_Birt
02-27-2007, 08:08 AM
Charles, I stand corrected. It seems that the conversion made some threads look like they were only four weeks old (perhaps that thread had a post within the last four weeks before conversion). I was able to find older posts by using the search function. I'll inquire about why this is...

forqnc
02-27-2007, 09:48 AM
I found the thread through the search function. I'd found it before the forum changed over and knew the key word was "winds". It is over 4 weeks, the last post is 5/03/2006.