View Full Version : Strictly military
Sarge
02-26-2007, 05:02 PM
Okay guys, I've had my machine for a week now. I still haven't actually cut anything yet. I have to get some heat out in the shop. I have been horsin' around with the software and here is my first trial piece. Any feedback would be appreciated. For those with old eyes like mine, I've now attached the mpc file.
Airborne!!!
BobHill
02-26-2007, 05:36 PM
Too small for my poor eyes to really see, Sarge. can you attach a bit larger image?
Bob
Sarge
02-26-2007, 05:56 PM
Sorry Bob.... I didn't double check the image size on the jpeg. I've attached the mpc file now.
Sarge
BobHill
02-26-2007, 09:04 PM
Sarge,
I like it. I just added a little plaque look to it, here attached. Note I've manually applied tabs.
Bob
IM2HAPPI
02-27-2007, 05:29 AM
Im by no means a guy but heres my 2 cents worth. Im afraid your going to have alot of chip out on that pattern. Blow it up with magnify tool and than go to view and check it out using the Isometric tool. I only know this cause I have been there ; )
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.