Spuddzilla
02-26-2007, 02:40 PM
Hi all,
I have been searching the forum for a few days, and I have not been able to find a fix for my scenario.
I have updated to .17 firmware. Running on a Sears Compucarve the machine has 1.5 hours of total carve time.
When I try to run a project the LCD displays: Please Check Home Sensor
after pressing stop:
Y/Z Homing fault Error 310
I did go though the PDF of taking off the top and verifying the ribbon cable under the z-pack is secure.
Under options and sensors the homing sensor always shows blocked. I have put air to the homing sensor and ran a q-tip though it. It doesn't appear that it has ever made contact with the flag, there is a 1/16" on in front and behind the flag.
Has anyone experienced and successfully cleared the 310 error?
I have been searching the forum for a few days, and I have not been able to find a fix for my scenario.
I have updated to .17 firmware. Running on a Sears Compucarve the machine has 1.5 hours of total carve time.
When I try to run a project the LCD displays: Please Check Home Sensor
after pressing stop:
Y/Z Homing fault Error 310
I did go though the PDF of taking off the top and verifying the ribbon cable under the z-pack is secure.
Under options and sensors the homing sensor always shows blocked. I have put air to the homing sensor and ran a q-tip though it. It doesn't appear that it has ever made contact with the flag, there is a 1/16" on in front and behind the flag.
Has anyone experienced and successfully cleared the 310 error?