DougM
02-26-2007, 01:50 PM
Howdy all!
I just "finally" finished doing my second project...yes I know very very slow..I was having one of those moments and forgetting about the 3 1/2 inch extra needed when staying under the rollers, and then couldn't figure out for the life of me why my carving was coming out at only 3 inches...sigh. Anyway I have some areas of the carving that are too small for a drumel sanding piece to fit, and I was wondering what else I could use to get into the small areas?
Also not having much experience with stains and finishes could anyone offer some advice? (I am a wood turner mostly doing pens and such so do the finishing on a lath using friction polishes)
Thanks everyone!
Doug
I just "finally" finished doing my second project...yes I know very very slow..I was having one of those moments and forgetting about the 3 1/2 inch extra needed when staying under the rollers, and then couldn't figure out for the life of me why my carving was coming out at only 3 inches...sigh. Anyway I have some areas of the carving that are too small for a drumel sanding piece to fit, and I was wondering what else I could use to get into the small areas?
Also not having much experience with stains and finishes could anyone offer some advice? (I am a wood turner mostly doing pens and such so do the finishing on a lath using friction polishes)
Thanks everyone!
Doug