PDA

View Full Version : new to the forum



bayfild
07-14-2014, 06:26 PM
Had a carvewright machine for quite a while, but never got into this part of it
. Could someone tell me how this pattern sharing works, how do you download them
and save them so you can carve them. and how can I post some that I have.?
Thanks in advance bayfild

henry1
07-14-2014, 06:47 PM
were you from usa or Canada I can call you much easier than typing send me a private message

fwharris
07-14-2014, 06:48 PM
Welcome to the forum! Do get a pattern or project from the forum left click on the file and it will either go into your "down load" folder or have a pop up window asking to open or save. I usually save it first and then open it from designer. Just pay attention to where your saved location is.

To post/share some of your work, either open a current category for what it is or start a new post. At the bottom right of the screen you will see "go advanced", click on that and it will open up the screen. Scroll down to "manage attachments" and it will open up the upload window. Click on browse to go to your files, select what you want and then upload.

bayfild
07-14-2014, 10:02 PM
Thanks,I got it