PDA

View Full Version : Layer Sequencing



zeke
02-25-2007, 10:09 PM
Howdy, I'm working on a piercing project. I am attaching winds_grill.mpc that I obtained in the forum to use the frame as a template. My piercing project is Test Pierce.mpc. I'm trying to determine how to move the flame behind the frame so that the depressions in the frame are eliminated. If you look at the winds_grill.mpc, this project does not have those depressions. The images appear to be behind the frame. Some of the graphic packages I have used have a "move to back", "move to front" type feature. Anyone know how I can accomplish this? Thanks for your help!

Julie Coffey
02-25-2007, 10:27 PM
Hi Zeke I was curious about this as well- so I tried it- I reduced the feathering to none and used the clip carving feature (circles icon if you right click) and did the inclusive selection. Is this what you were shooting for?

Hope I did this right and it helps.

Julie :)

pkunk
02-25-2007, 10:28 PM
I turned off feathering.

Julie Coffey
02-25-2007, 10:31 PM
Ok I was 1/2 right ::cheezy grin::

J

zeke
02-28-2007, 05:02 PM
Julie, out of curiosity, how did you figure this out? Thanks for giving it a try pkunk!

Best Regards,
Zeke