PDA

View Full Version : bit issues



t-townwilson
06-13-2014, 10:07 PM
I recently broke a 1/8" cutting bit, and wondered if the factory-applied sleeve/adaptor can be removed and reused. Not sure how I could remove it, I just wondered if I should just throw it away.

Also, can I use a bowl-cutting bit on CW? if so, is there some way to add bits to the catalogue of bits in Designer?

Thanks:)

bergerud
06-13-2014, 10:22 PM
The adapters are useful. They can be reused on other carbide bits so save it. See: http://forum.carvewright.com/showthread.php?24600-CT-Adapters-Move-Easily-with-Heat&p=217273#post217273

The bits in the list are the only ones. All you can do is pick one close the the size of one you want to use.