View Full Version : How to make a rounded plaque base
Gary Koval
05-19-2014, 07:16 AM
I am making a Captain America plaque and base, and was hoping someone could explain how I would go about making a slot in the base piece feathered on both ends, and not sides, to accept a round plaque and also tilted so that the piece tilts backward slightly. The slot would be approx. 1/2" wide and 2" long and 1/4" deep. Both pieces are being carved in Corian.
Thanks,
Gary
racer
05-19-2014, 08:01 AM
If you have the 3d draw your rectangle the size you need then extrude arc to the size you need. see mpc
bergerud
05-19-2014, 09:23 AM
Is it something like this you want?
(Made in 1.187 so you have to turn off floor feather if opened in 2.0)
Gary Koval
05-21-2014, 06:05 AM
Thanks everyone again. I will carve both to see which ends up best.
Gary
Gary Koval
05-30-2014, 11:24 AM
I carved both and both worked very well, here are the final pics of the award...
Gary
lynnfrwd
05-30-2014, 12:06 PM
That looks great. At first, I thought you had the name off center, then I saw that you hid the last name. Good job.
Gary Koval
05-31-2014, 08:14 AM
Thanks Connie,
Love the CX since it's back!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.