mannwranglers
05-14-2014, 06:43 PM
69478
This happened today to my carvewright machine....
The bottom part, where the flex shaft goes in to the cutting motor fell apart or came off.....I don't know what happened to it.
I was in the bathroom when I heard a change in the motor running.
Is there a solution to this other than having to buy a new cutting motor or can I get another housing for my cutting motor??
Any advice will be very appreciated!!!!
George Taylor
REDNECK TECH.
Florence,SC
This happened today to my carvewright machine....
The bottom part, where the flex shaft goes in to the cutting motor fell apart or came off.....I don't know what happened to it.
I was in the bathroom when I heard a change in the motor running.
Is there a solution to this other than having to buy a new cutting motor or can I get another housing for my cutting motor??
Any advice will be very appreciated!!!!
George Taylor
REDNECK TECH.
Florence,SC