PDA

View Full Version : ZrN coated bits



zan29
04-15-2014, 03:51 AM
Found this website this morning for bits. Would they work on the CW?
http://www.toolstoday.com/p-6225-solid-carbide-cnc-2d-and-3d-carving-tapered-ball-nose-conical-ball-flat-bottom-end-mill-zirconium-nitride-zrn-coated-router-bits.aspx

bergerud
04-15-2014, 08:49 AM
I have bought bits from this site. I think the 46280 and the 46282 are the same as the bits Jeff Bert sells on the Soigeneris site. The 46284 I have bought as an intermediate bit between the normal carving bits and the deep bits. It has a 1.5" depth of cut. It has a 1/8" ball. I have not yet found a good intermediate bit with 1/16" ball and 1.5" depth of cut. Also check out

http://www.carbideprocessors.com/tapered-ballnose-spiral-1-8-1-4-dia-1-1-2-cut-length-1-4-shank-vortex-2215/

(Do not buy the 1/16" ball. It is not as pictured and very thin.)

ktjwilliams
04-25-2014, 07:50 PM
Thanks for the info ... I am alwayzzzzz on the hunt for bits... 1/16th's are hard to find with a decent length of cut ...