Designer procedure

[Mike1]

I have designed a litho pattern and would now like to change the direction of the pattern and board togather by 90 degrees so that it will fit in my sled for carving. It is now 10"L x8"w. My sled is the opposite. It was just easier for me to design the pattern this way. Is this possible? I did do a search but I may not be asking this properly. Thank you.

[fwharris]

Just start over by making your new board size 10" L X 8" wide. Then bring in your litho image and rotate it 90* and size to fit your layout.

[henry1]

yes it is possible to do what you want to do

[Mike1]

It's not just a single pattern. There are 5 plus two drill holes. Thank you.

[James RS]

Not sure, but could you select as a whole and save it as a pattern?
Then just re import it?

[Mike1]

James, I tried that. No luck. I just re-did the pattern. There must be some way to do that. Thanks