texasinmi
04-10-2014, 05:46 PM
I start a carve, measurement, bit load and board sensing goes as expected. The carve starts and when the bit begins to cut I get a y axis stall.
I did a cut motor test, OK. I do a y axis test and get these numbers:
M=256
a= (multiple tests) 63.68, 45.05, 41.60, 50.50
When the y axis test is closest to the keyboard, I get a vibration that goes away as the truck moves to the other side.
Ideas?
texasinmi
I did a cut motor test, OK. I do a y axis test and get these numbers:
M=256
a= (multiple tests) 63.68, 45.05, 41.60, 50.50
When the y axis test is closest to the keyboard, I get a vibration that goes away as the truck moves to the other side.
Ideas?
texasinmi