PDA

View Full Version : Sears CompuCarve for sale!


gtj44
04-01-2014, 03:57 PM
History - I bought one of the earlier systems. After 6 months had some issues and sent it back to Carvewright under warranty. During the shipping back to me, it fell off the UPS truck and was damaged. They sent a me a new machine, which is the one being listed for sale. I never had any issues with this one.

Last year I bought and installed the new carvetight spindle. I only carved one short item with it. It did make the machine run smoother and slightly quieter.

I have the original box and foam to ship it in.

Also have the memory card and reader.

No bits. Saving them for a CX

S/N - A. G003.269
Cut Time - 21 Hrs 30 min.
On Time - 43 Hrs 26 min
Servo Time - 34 Hrs 7 Min
Scanning Time - 9 Hrs 32 Min

Make Offer

Cheapest shipping may be Fed Ex
Pick up available in Buffalo, NY - It's safe to come here, the snows finally gone, maybe!

Thanks for Looking
judgejrt
04-01-2014, 05:21 PM
Sent you a p.m.
gtj44
04-01-2014, 06:07 PM
I'd like $800.00 plus shipping. It does have the new carve tight spindle and low cut hours! Never ran any long hour projects, only small signs and projects.
henry1
04-01-2014, 06:37 PM
I'd like $800.00 plus shipping. It does have the new carve tight spindle and low cut hours! Never ran any long hour projects, only small signs and projects.

you did say if its B or C machine
unitedcases
04-01-2014, 06:44 PM
The very first post shows the serial number starting with an A.
Digitalwoodshop
04-01-2014, 07:05 PM
Does it have the A907 14 pin FFC Cable System? or the "A" version 18 pin?

Has the Board Sensor ever been replced with a glued version.

Has the L2 Power Supply coil had the Extra Glue added?
henry1
04-01-2014, 07:40 PM
The very first post shows the serial number starting with an A.

I seen it now thx an A wow way to much
gtj44
04-01-2014, 07:48 PM
I never had the glued board sensor or power supply changed, to be honest, never knew about that upgrade.
I'll check to see what pin configuration the cable has.

I have in my original post to make an offer.
lynnfrwd
04-01-2014, 08:10 PM
A907 is already done since carvetight upgrade was done.
gtj44
04-02-2014, 09:36 AM
Al Who mentioned if the Board Sensor was replaced with a glued version and L2 Power Supply coil had Extra Glue added?
What does this do? Does it help the performance or maintenance of the machine?
Is it an up grade that is available?

Thanks
fwharris
04-02-2014, 11:41 AM
Al Who mentioned if the Board Sensor was replaced with a glued version and L2 Power Supply coil had Extra Glue added?
What does this do? Does it help the performance or maintenance of the machine?
Is it an up grade that is available?

Thanks

On the power supply LHR started applying more glue/caulking to some of the components to help with the vibrations issues of breaking the solder connections. They also started sealing the board sensor to help with getting dust inside the sensor.