PDA

View Full Version : Madonna



eelamb
03-25-2014, 12:38 PM
An old favorite. This one will carve nicely in the new software. If someone post the PTN after it is unwrapped, then others may enjoy it too. But size would need to be changed. This one is about 12" by 3.7".
File came for the internet, I just resized it to fit the new rotary jig.

cestout
03-25-2014, 12:43 PM
That is beautiful Ed. Was it an STL?
Clint

fwharris
03-25-2014, 01:11 PM
Here it is.. I could not upload the mpc as it is to big so here is a down load link

https://www.mediafire.com/?5bwqene1racmd98

eelamb
03-25-2014, 01:42 PM
Clint, it was a 3ds. I converted it using silo to obj, and resized it. Then took it into meshlab for the stl conversion. Images are from meshlab.
Kept importing it into designer to check the size, and resized it again and again till I got it under the 12" tall or less than 4.25" wide (which ever came first).

eelamb
03-25-2014, 01:45 PM
Here it is.. I could not upload the mpc as it is to big so here is a down load link

https://www.mediafire.com/?5bwqene1racmd98
Floyd it is an MPC so will do me no good nor anyone else with 1.187 but thanks anyway. But anyone with designer 2x can use it. I will unwrap it for designer 1.187, and post it here.

eelamb
03-25-2014, 01:58 PM
Sorry guys, silo does not have a centering feature to force the model on the center of the grid (x,y,z) or at least I do not know how to do it, nor do I know how to center it in blender. Therefore the model shows 144" wide in silo, and I have not figure out how to lay it out properly for unwrapping.

eelamb
03-26-2014, 09:23 AM
Well after much struggling, I figured out how to center the object (manually) on the grid. So here is the madonna pattern for anyone with designer 1.187, and Ed's Rotary jig.