View Full Version : material used
aokweld101
02-28-2014, 10:56 AM
I was wanting to know if you could use polyethylene or polypropylene for lithopone carving ? the melting point of this material is 360 degrees
CNC Carver
02-28-2014, 11:09 AM
I've used polypropylene.
aokweld101
02-28-2014, 11:16 AM
I've used polypropylene.
did it turn out all right, I found some at .187 thick 12" x 24"
CNC Carver
02-28-2014, 11:44 AM
67878This was my first try came out ok.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.