Transfering Patterns???

[chanin]

Newbie here,
OK I have a question, I used the prope to make a patern, but when I carve the pattern it comes out way to small. I would like to know how to carve the same size pattern that I copied. I am looking for an exact duplicate. Is there a way to do this?
Chanin

[lynnfrwd]

Are you selecting Stay Under Rollers on set up?

[fwharris]

Did you get a "scaling" message when it was measuring the board?

When you place a pattern on the board un check the "fit to board" box. What size did you have the pattern in your project?