Hesitation!!

[mannwranglers]

Any body had their machine to stop when it went to cross cut a board??
It's been about 5 months since I did any carving or cutting with it.
Guess I got to do some greasing and fighting to it before I start doing an actual carving.

[lynnfrwd]

I don't know too many people using it to cross cut a board. Any error messages?

[Digitalwoodshop]

Hey Buddy !!!!

Sounds like the machine is COLD.....

A little WD 40 on the roller rail bearings and what is the condition of the Y Gear Box?

Take Care,

AL